1. Why FLASH + CLEVER are inseparable
FLASH targets EHP and microsporidians via spore-wall disruption. CLEVER targets Vibrio via Quorum Sensing peptides and biofilm breakdown. These two pathogens typically co-occur in white feces and weak hepatopancreas — using one alone always leaves the other pressure unaddressed.
2. Combined dosage
Mix with clean water, blend into feed, coat with ATOMIC, dry 20 min:
- Routine prevention: FLASH 3 g/kg + CLEVER 2 – 3 g/kg, 2 meals/day, from day 15 onward.
- WFS / EHP treatment: FLASH 5 g/kg + CLEVER 5 g/kg, 4 meals/day, 5 – 7 consecutive days.
- TPD-history ponds: use prophylactically from day 1 after PL stocking.
3. When to use FLASH + CLEVER
- Ponds for EU/US export — zero antibiotic residue tolerance.
- Ponds with antibiotic resistance history, poor antibiogram results.
- WFS with abnormally high FCR (suspected EHP).
- Post-acute recovery — sustained long-term pathogen suppression needed.
Verbatim from the FLASH (500 g) label — synced with the product page to avoid drift.
Mix the product with sufficient clean water, thoroughly mix into feed, coat with ATOMIC or a suitable coating product, and let dry for 20 minutes before feeding shrimp. During farming: Feed from the start at 3 g/kg feed, 3 meals/day. During and after disease treatment: 5 g/kg feed, 4 meals/day. Note: Dosage may vary depending on shrimp health and actual farming conditions. Seal tightly, zip the bag immediately after use if the product is not fully consumed.
- Optimal control of Quorum Sensing without affecting beneficial bacteria.
- Strongly inhibit the growth of harmful bacteria.
- Reduce intestinal dysbiosis.
- Reduce stress in farmed animals, significantly improve hepatopancreas.
Starting a new cycle and want to skip antibiotics?
Contact Than Vuong via Zalo 0867 957 568 — our technicians design a full-cycle FLASH + CLEVER plan for your pond.